Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 12-17-2014, 08:04 AM   #1
bart40
Member
 
bart40's Avatar
 
Join Date: Sep 2013
Location: oklahoma
Posts: 38
Default Removing door handles from a 40

I need to remove the outside door handles and key holes from my 40. (It's a 4 door so I've got a few) I've done some staring at it but haven't figured it out. Any thoughts? Thanks.
bart40 is offline   Reply With Quote
Old 12-17-2014, 09:07 AM   #2
Kurt in NJ
Senior Member
 
Kurt in NJ's Avatar
 
Join Date: May 2010
Location: on the Littlefield
Posts: 6,140
Default Re: Removing door handles from a 40

turn them like opening the door, wiggle and pull--after the screws are out

there is a set screw in from the side for the lock cylinder
Kurt in NJ is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 12-17-2014, 09:35 AM   #3
Kube
Senior Member
 
Kube's Avatar
 
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,937
Default Re: Removing door handles from a 40

You do not need to remove the lock to remove a handle. You do need to remove the screw (it's in the door jamb) though. Then, simply pull it out.
The lock cylinders can be a test in patience if the set screw is rusted in. the screw is a #8 if I recall correctly. Being that small and threaded deeply in to a sheet metal "sheath", well, if it is rusted, think "lots of patience". I typically will remove the door panel and heat the threaded "sheath" and slowly twist the set screw back and forth to remove it.
Authentic set screws had a slotted head which makes this task even more of a challenge.
__________________
"I can explain it for you. However, I can't understand it for you".
Kube is offline   Reply With Quote
Old 12-17-2014, 10:23 AM   #4
TJ
Senior Member
 
TJ's Avatar
 
Join Date: May 2010
Location: Napa,California
Posts: 6,007
Default Re: Removing door handles from a 40

If you are not interested in authenticity replace the set screws with an allen head set screw.
TJ is offline   Reply With Quote
Old 12-17-2014, 06:12 PM   #5
bart40
Member
 
bart40's Avatar
 
Join Date: Sep 2013
Location: oklahoma
Posts: 38
Default Re: Removing door handles from a 40

Sponsored Links (Register now to hide all advertisements)
Thanks all! It worked.
bart40 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:13 PM.