Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-06-2020, 09:52 PM   #1
ryanheacox
Senior Member
 
ryanheacox's Avatar
 
Join Date: Apr 2013
Location: Northwest CT
Posts: 810
Default Remove sector needle bearings

Iíve been tearing my steering box/column apart over the last few days and to my surprise it had already been converted to needle bearings. The sector, worm and races were shot but everything else was in decent shape

The bearings installed are Torrington bearings and seem to be in decent shape but I might want to take them out to make sure. I do want to replace the seal at least, what would be the best way to remove it? I canít tell if the housing was machined from both ends and the bearings were then pressed from each side or if they were pressed in with a spacer and everything goes in one end? I donít want to try pressing everything out and inadvertently destroy one of the bearings.
ryanheacox is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:52 AM.