|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-06-2014, 08:39 PM | #1 |
Senior Member
Join Date: Jun 2010
Location: Maryville,Tn
Posts: 302
|
Tillotson Carb Question
The screwdriver slot is stripped in the small brass jet in the bottom of the carb bowl. Im goin to try to drill it out...does anyone know what size tap I'll need to clean out the threads?
|
11-06-2014, 09:00 PM | #2 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Tillotson Carb Question
Try a left hand set of drill bits and go slow. The bit may bite and spin the jet out.
It did for me, and Harbor Freight sells left hand bits. |
Sponsored Links (Register now to hide all advertisements) |
|
11-06-2014, 09:30 PM | #3 |
Senior Member
Join Date: Jun 2010
Location: Maryville,Tn
Posts: 302
|
Re: Tillotson Carb Question
Hey thanks Tom ! I'll be goin to Harbor Freight Sat !
|
11-06-2014, 10:21 PM | #4 |
Senior Member
Join Date: Apr 2014
Location: La Verne California
Posts: 272
|
Re: Tillotson Carb Question
I had the same scenario. I used a small easy out after soaking it for a day in PB blaster and it came out easily.
|
11-06-2014, 10:23 PM | #5 |
Senior Member
Join Date: Dec 2011
Location: New hope Minnesota
Posts: 742
|
Re: Tillotson Carb Question
Go with what Tom say's, but I believe the jet thread is 8/32.
|
11-07-2014, 06:01 AM | #6 |
Senior Member
Join Date: Jun 2010
Location: Maryville,Tn
Posts: 302
|
Re: Tillotson Carb Question
Sponsored Links (Register now to hide all advertisements)
|
11-08-2014, 11:20 PM | #7 |
Senior Member
Join Date: Jun 2010
Location: Maryville,Tn
Posts: 302
|
Re: Tillotson Carb Question
Thanks Tom Wesenburg...the reverse drill bits did the trick!
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|