06-13-2010, 01:19 PM | #1 |
Senior Member
Join Date: May 2010
Location: Georgetown Divide Kelsey ca
Posts: 868
|
U bolt removel
I'm salvaging parts off whats left of a 1928 chassis. The front spring u bolt nuts refused to break loose. heat cycles pb blaster electric impact air impact. Broke out the 4 ft cheater after 3 days still would not budge. So I tried to tighten them and they broke loose. I'm not sure what helped but there off and in the parts barn.
__________________
Dennis in Kelsey ca |
06-13-2010, 01:37 PM | #2 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: U bolt removel
I don't know what it is, but tightening them first, as you say, then loosen them, always works.
Also heating them then a cold dash of water works to. Pluck |
Sponsored Links (Register now to hide all advertisements) |
|
06-13-2010, 11:11 PM | #3 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,215
|
Re: U bolt removel
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|