The Ford Barn

Bob from Northport · 05-21-2018, 03:29 PM

Can anyone advise the correct length of the two screws that attach the two lower brackets on the rumble seat back cushion to the truck lid??
10x32xhow long???

Thanks!!!

Atlasboy · 05-21-2018, 04:26 PM

I own a 1931 Car with it's original Rumble Seat Cushion and Backrest ; The original screws are #12-24 Round head screws, 5/8 in length.

figment · 05-21-2018, 07:03 PM

I used a round head screw , flat washer , lock washer and probably less than 1 inch long . I would remove it and measure but it is to hard to re-install . Norm

jw hash · 05-21-2018, 09:35 PM

Sponsored Links (Register now to hide all advertisements)

I`m with Atlasboy 12- 24- 5/8'

05-21-2018, 04:26 PM	#2
Atlasboy Junior Member Join Date: Oct 2013 Location: Tyrone, Georgia Posts: 28	Re: Rumble seat question I own a 1931 Car with it's original Rumble Seat Cushion and Backrest ; The original screws are #12-24 Round head screws, 5/8 in length.

05-21-2018, 07:03 PM	#3
figment Senior Member Join Date: May 2010 Posts: 332	Re: Rumble seat question I used a round head screw , flat washer , lock washer and probably less than 1 inch long . I would remove it and measure but it is to hard to re-install . Norm

05-21-2018, 09:35 PM	#4
jw hash Senior Member Join Date: May 2010 Location: Auburn Washington Posts: 2,552	Re: Rumble seat question Sponsored Links (Register now to hide all advertisements) I`m with Atlasboy 12- 24- 5/8'

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-21-2018, 03:29 PM	#1
Bob from Northport Senior Member Join Date: May 2010 Location: 215 E. 6th Street Northport, Michigan 49670 Posts: 941	Rumble seat question Can anyone advise the correct length of the two screws that attach the two lower brackets on the rumble seat back cushion to the truck lid?? 10x32xhow long??? Thanks!!! __________________ Bob from Northport Northport, Michigan