|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-15-2019, 06:21 PM | #1 |
Senior Member
Join Date: Apr 2015
Location: Olga, WA
Posts: 184
|
Borg Warner Torque Tube Stuck
Having no luck detaching old BW overdrive rear torque tube from banjo. All bolts are out but there is no movement of the tube, even with wood block and hammer. I notice there are extra holes in the BW rear torque tube flange, and I am wondering if I need to run some bolts into those holes to pry the flange loose. Feels like the drive shaft might be integral to the tube in some way, unlike stock Modal A setup. Picture attached.
|
10-15-2019, 07:27 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,751
|
Re: Borg Warner Torque Tube Stuck
|
Sponsored Links (Register now to hide all advertisements) |
|
10-15-2019, 07:38 PM | #3 |
Senior Member
Join Date: Apr 2015
Location: Olga, WA
Posts: 184
|
Re: Borg Warner Torque Tube Stuck
Yes. Unfortunately I could not find information about the connection of the rear torque tube to the banjo....
|
10-16-2019, 08:34 PM | #4 |
Senior Member
Join Date: Apr 2015
Location: Olga, WA
Posts: 184
|
Re: Borg Warner Torque Tube Stuck
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|