|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-12-2020, 08:25 PM | #1 |
Member
Join Date: Mar 2012
Location: Waterloo,CA
Posts: 50
|
'75 pinto 10" rotor and caliper
I'm sure this has come up in the past but i searched for it and got nothing. I have a '34 sedan with mustang front end. The caliper has a casting number 4109 and an emblem " Ford". It has a 10" rotor that was a 4 bolt rotor but it has been redrilled for 5 studs. I measured it and got 4.25" spacing but maybe i measured wrong because all i can find for 10" is either 5" or 4.75" or 4.5". Any one have any experience with this setup??
I want to get new rotors, calipers and pads. |
05-12-2020, 08:43 PM | #2 |
Senior Member
Join Date: May 2010
Location: Southern California
Posts: 7,032
|
Re: '75 pinto 10" rotor and caliper
I don't think I have ever seen this topic in the past. You would probably have better luck on HAMB: https://www.jalopyjournal.com/forum/...ssage-board.5/
Good luck. Charlie Stephens |
Sponsored Links (Register now to hide all advertisements) |
|
05-12-2020, 11:34 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Mn
Posts: 2,411
|
Re: '75 pinto 10" rotor and caliper
Quote:
While some newer Fords do use a 5 lug 4.25" bc., there is Good Chance you are probably measuring wrong. Because there is NO Stud 180 degrees across on a 5 lug bc. pattern you measure the way the picture diagram below shows.
__________________
If mama ain't happy, ain't nobody happy. But if daddy ain't happy...RUN |
|
05-13-2020, 12:50 AM | #4 |
Senior Member
Join Date: Feb 2014
Location: West Hempstead, New York
Posts: 167
|
Re: '75 pinto 10" rotor and caliper
I have N.O.S. D90 / 7026D90 ++ Asbestos ++ Brake Pads -- if you would like the nicest, softest, smoooooothest braking system Brake Pads known to mankind...
Always best to simply call me --- Craig --- 516 - 485 - 1935..... New York.... |
05-13-2020, 08:57 AM | #5 | |
Senior Member
Join Date: May 2010
Location: Napa,California
Posts: 6,037
|
Re: '75 pinto 10" rotor and caliper
Sponsored Links (Register now to hide all advertisements)
Quote:
|
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|