Go Back   The Ford Barn > To The Editors > Questions & Suggestions

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 07-01-2019, 08:49 AM   #1
Huff
Senior Member
 
Join Date: May 2010
Location: Palmyra Pa.
Posts: 185
Send a message via ICQ to Huff Send a message via AIM to Huff
Default Stiff clutch pedal

I put a new clutch and pressure plate 11" in a 52 ford f1 and the pedal pushes hard.The truck had a 11" clutch in it before. Not a pleasure to drive. I have new brass bearings all have been greased.The old clutch did not push hard but had bad clutch chatter. Fly wheel was resurfaced all linkage is good. Any help other than put in a 10" pressure plate and clutch. Thanks Huff
Huff is offline   Reply With Quote
Old 07-01-2019, 10:13 PM   #2
redmodelt
Senior Member
 
redmodelt's Avatar
 
Join Date: May 2010
Location: Portland OR
Posts: 4,511
Default Re: Stiff clutch pedal

You need to ask on the Early V8 forum. This section is not for car questions.
__________________
I know the voices aren't real but damn they have some good ideas!
redmodelt is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 07-19-2019, 09:42 AM   #3
Orich
Junior Member
 
Join Date: Jun 2018
Posts: 2
Default Re: Stiff clutch pedal

Not all clutches are the same poundage like the half ton or a 3/4 tons. Since these are old classic vehicles the supplier may only can get one so they don't have to stock two styles. Green sales may have an OEM pressure plate. Or have the Pressure Plate replaced the-spring..
Orich is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:09 AM.