|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
|
07-14-2014, 07:11 AM | #1 |
Senior Member
Join Date: May 2010
Location: Proctorville
Posts: 1,582
|
Yes, they are still out there NUMBER 2
Drug another Car out of storage (barn) that was parked in 1982, picked up a 1939 Sedan Lincoln Zephyr. Ceiling was starting to fall down and rock wool insulation and pieces of sheet rock had fallen on top of car. All the tires were flat, I took air compressor and aired up. Took four of us to roll car ( very heavy compared to early V8's and model A's ) Pulled up in trailer with winch and home we came, unloaded Saturday evening and had several people came over and inspected old car. Yesterday afternoon I removed plugs and put automatic transmission fluid in all cylinders ( 12 ) and let set until late evening. My son and I went to garage and I placed car in 2nd gear and we rocked car, got the engine to turn over. I also drained oil and put a gallon of diesel in car and will drain out today. Going to remove carb and distributor and clean/inspect/lube. Still have not got trunk open, no key, locksmith maybe today, hope full of 39 silver dollars!!!! Will go for a start later this week.
. . . home in OHIO . . Original heads and have additional intake, several carbs came with car . . Have air filter, fender skirts, extra wheel drum, and coil. . |
07-14-2014, 07:24 AM | #2 |
Senior Member
Join Date: May 2010
Location: pittsfield, MA
Posts: 2,086
|
Re: Yes, they are still out there NUMBER 2
Great Find!!!!!!!
|
Sponsored Links (Register now to hide all advertisements) |
|
07-14-2014, 07:31 AM | #3 |
Senior Member
Join Date: Oct 2010
Location: Callahan Fla
Posts: 1,149
|
Re: Yes, they are still out there NUMBER 2
Great find. How much did it set you back?
__________________
Wanted, a car with a " Dynaflex Superflowing Unijet Turbovasculator which is Syncromeshed to the Multicoil Hydrotensioned Dual vacuum Dynomometer. " |
07-14-2014, 03:38 PM | #4 |
Senior Member
Join Date: May 2010
Location: Oakdale,Ca
Posts: 1,323
|
Re: Yes, they are still out there NUMBER 2
|
07-14-2014, 11:26 PM | #5 |
Senior Member
Join Date: Oct 2010
Location: Callahan Fla
Posts: 1,149
|
Re: Yes, they are still out there NUMBER 2
I've done that as well.
__________________
Wanted, a car with a " Dynaflex Superflowing Unijet Turbovasculator which is Syncromeshed to the Multicoil Hydrotensioned Dual vacuum Dynomometer. " |
07-15-2014, 03:15 PM | #6 |
Senior Member
Join Date: May 2010
Location: Ellsworth Michigan
Posts: 1,807
|
Re: Yes, they are still out there NUMBER 2
Sponsored Links (Register now to hide all advertisements)
Wow that is quite a retrieval. Good to see some of that old iron getting back into circulation. There was a fella with one around here a year or so ago, he made a few small shows. It was for sale, if memory serves, he was asking $30K for it but I can't remember what year it was, I'm thinking '39. I haven't seen it yet this year. |
07-19-2014, 02:13 PM | #7 |
Member
Join Date: Sep 2010
Location: woodbine , maryland
Posts: 31
|
Re: Yes, they are still out there NUMBER 2
Bruce you can get some good tips on restoring this car at Steve's Auto Restorations he is doing a 4 door as I write this. I was glad you decided to go with the Big Block Chevy and Auto trans. I would limit the top chop to not more then 3 inches.
|
08-22-2014, 08:17 AM | #8 |
Member
Join Date: Aug 2014
Location: Illinois
Posts: 95
|
Re: Yes, they are still out there NUMBER 2
Wow!!! Great find! I'm sure you will have fun with that one. What a great story.
__________________
"Thrifty Sixty" Ford V8 for 1938 |
08-22-2014, 04:15 PM | #9 |
Senior Member
Join Date: May 2010
Location: Proctorville
Posts: 1,582
|
Re: Yes, they are still out there NUMBER 2
Ken, everyone, thanks for info, it was a great day in the Neighborhood as Mr. Rogers would say. Went to friends house/garage this morning and picked up a lathe that I traded for over a year ago, it is now at my garage.
Next went to unload lathe and big rain storm came and I went in garage to check on my gas fill tube pipe. I cut up an old inner tube yesterday and took a hose clamp and made a sock around fill tube and filled with motor oil and PB blaster (did not have any automatic transmission fluid). Removed the inner tube and wiped off oil and tried my spanner wrench, just a little hammer action and it was loose, GREAT!!! Next I found that the fill tube would not come out. Next removed the gas gauge wire, the three bolts from tank ( lost some skin on those ). Next moved tank to passenger side and got fill tube out, double GREAT. Last but not least I found just the right spot and tank came right OUT!! Soaked in sweat and Pennsylvania dirt I went home, now to find a radiator shop to clean the fill tube and tank, I will seal with a POR product, again thanks for info, BJ . lathe for my use . . 39 tank and fill tube, looks like minor rust and dirt, . . side view of tank and filler tube . |
07-15-2014, 04:55 AM | #10 |
BANNED
Join Date: May 2010
Location: Michigan / Ontario border, Sarnia, Ontario. 50 miles from Detroit and 150 from Toronto.
Posts: 5,800
|
Re: Yes, they are still out there NUMBER 2
|
07-14-2014, 07:38 AM | #11 |
Senior Member
Join Date: May 2010
Location: Kaufman, TX
Posts: 822
|
Re: Yes, they are still out there NUMBER 2
Looks like a nice solid car..keep us posted on the start up.
|
07-14-2014, 08:33 AM | #12 |
Senior Member
Join Date: Jul 2011
Location: Oakland County, Michigan
Posts: 562
|
Re: Yes, they are still out there NUMBER 2
WOW, what a find! Looks great. Keep us posted on your progress...
|
07-14-2014, 08:35 AM | #13 |
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
|
Re: Yes, they are still out there NUMBER 2
awesome find. Congratulations.
__________________
Life is like a roll of toilet paper. The closer to the end, the faster it goes. It is better to be seen, than viewed. "We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm". |
07-14-2014, 09:02 AM | #14 |
Senior Member
Join Date: Feb 2013
Location: Eureka Calif.
Posts: 968
|
Re: Yes, they are still out there NUMBER 2
The next time you go barn shopping,take me with you. Very nice!
|
07-14-2014, 09:01 AM | #15 |
Senior Member
Join Date: Dec 2010
Location: North of sandy ago, CA.
Posts: 2,064
|
Re: Yes, they are still out there NUMBER 2
Good you found it when you did. Not much damage.
Will make a great driver. Bruce
__________________
Works good Lasts long time |
07-14-2014, 09:21 AM | #16 |
Senior Member
Join Date: May 2010
Location: Colfax, CA
Posts: 387
|
Re: Yes, they are still out there NUMBER 2
Excellent find! I hope you and your son have a great time with this one. Congrats
|
07-14-2014, 09:27 AM | #17 |
Senior Member
Join Date: Aug 2012
Location: Takoma Park, MD
Posts: 2,817
|
Re: Yes, they are still out there NUMBER 2
I hope you can see that we are all green with envy. A Zephyr is a dream find for me. A couple ideally, LOL!
|
07-14-2014, 09:33 AM | #18 |
Junior Member
Join Date: May 2010
Location: SC
Posts: 23
|
Re: Yes, they are still out there NUMBER 2
Bruce,
You keep coming up with some very fine cars!!! |
07-14-2014, 09:54 AM | #19 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: Yes, they are still out there NUMBER 2
Bruce, that is outstanding!!!
__________________
Imagination is more important than knowledge. |
07-14-2014, 10:04 AM | #20 |
Senior Member
Join Date: Jan 2012
Location: Nine Mile Falls,WA
Posts: 900
|
Re: Yes, they are still out there NUMBER 2
Nice find. Would like to see more photos once you wash it.
__________________
The sign of a good craftsman is how well they cover up their mistakes. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|