Crab work "kinda" ?

[BUBBAS IGNITION]

I do tons of these crab distributors mostly using a flatcap. Its very seldom i get one of the "rabbit ears" bail cap arrangement ..
I kinda like the look , especially with boots and wires etc....

[Tim Ayers]

I do too...

[38bill]

Sure you like it now but not so much after you try to push all the wires into the cap while keeping them in the connectors.

[BUBBAS IGNITION]

Originally Posted by 38bill

Sure you like it now but not so much after you try to push all the wires into the cap while keeping them in the connectors.

Actually brillman makes a connector for the 7mm solid wires that "snaps" into the cap ,most dont know the cap is designed with a snap section to hold the wire into the cap.

Yours is next for tomorrow , i will get us a picture of the connector...
https://brillman.com/product/old-sty...coil-terminal/

[BUBBAS IGNITION]

Bills patient ready for assembly.......

[petehoovie]

Sponsored Links (Register now to hide all advertisements)

What's the story on your clean hands and fingernails?....

[BUBBAS IGNITION]

Originally Posted by petehoovie

What's the story on your clean hands and fingernails?....

Actually you wasnt to notice that.

I have a part timer (Terry) that works three aft a week and cleans all the parts up, glassbeads , polishes etc. So when i get them the parts are spotless!!!

Dont tell him but hes the unsung hero of Bubbas!!!!!! I will try to sneak a picture or two wed aft......

[Tinker]

Rabbits are cool. No worse then stuffing wires in a helmet. well... maybe a bit

[MGG]

Originally Posted by 38bill

Sure you like it now but not so much after you try to push all the wires into the cap while keeping them in the connectors.

I agree. You have to stuff 9 wires into a cap which is only a little bit bigger than the helmet caps which hold 4 wires.

[BUBBAS IGNITION]

Originally Posted by BUBBAS IGNITION

Actually you wasnt to notice that.

I have a part timer (Terry) that works three aft a week and cleans all the parts up, glassbeads , polishes etc. So when i get them the parts are spotless!!!

Dont tell him but hes the unsung hero of Bubbas!!!!!! I will try to sneak a picture or two wed aft......

Terry on the belt sander , cleaning them up......

[BUBBAS IGNITION]

Originally Posted by BUBBAS IGNITION

Bills patient ready for assembly.......

shes a beauty , ran at 6,000 rpm for a few minutes . I love these cast iron units...

[38bill]

I was going to save it as a spare but I think its going in the truck asap. Hopefully the weather will cooperate and I can get it on the road before it snows.