Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-29-2020, 11:30 PM   #1
KCTA Chris
Senior Member
 
KCTA Chris's Avatar
 
Join Date: May 2010
Posts: 142
Default Did I get a defective U-Joint?

I had a random noise in the running gear around 30 mph letting off gas. Happened once, then again, and now constant... reading past posts it sounds very much like a U joint problem. I noticed my ujoint shaft bolt and retaining washer was a little loose and could be the cause the problem, while my Ford Ujoint looked ok, to be safe I ordered a replacement joint. I read about the defective ones a few years back and also the Bob Drake Issues so ordered from a trusted “A” vendor. This is what I got.... I immediately noticed the splines are not centered in the yoke, in fact the casting is offset leaving some of the yoke egde sticking out further on one side. Before I call to send back wanted to make sure this is defective? Or is it useable and nothing to worry about?
Attached Images
File Type: jpeg C1C4D05D-9B01-4E49-8B0E-E52BA7EA20DE.jpeg (22.3 KB, 134 views)
KCTA Chris is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:02 PM.