Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page 49-53 Load A Matic problem

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 12-06-2017, 03:31 PM   #1
BUBBAS IGNITION
Senior Member
 
BUBBAS IGNITION's Avatar
 
Join Date: May 2010
Location: SPEEDWAY INDIANA
Posts: 4,148
Default 49-53 Load A Matic problem
Sponsored Links (Register now to hide all advertisements)
Just another review of a typical 49-53 Problem. The primary lead wire runs under the point plate. Over time the plate rotates back and forth wearing the lead wire insulation off . This one ran fine but died when vac was applied t diaphrahm... Pain in the butt to replace and should be replaced with correct Ford lead wire . proper resistance and end hook ups...

and you cant use tape or shrink tubing as it will restrict advance operation....
Attached Images
File Type: jpg IMG_2333.jpg (66.9 KB, 39 views)
__________________
If it Makes Spark, we do it !!!!
www.bubbasignition.com
[email protected]
Last edited by BUBBAS IGNITION; 12-06-2017 at 08:02 PM.
BUBBAS IGNITION is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:28 AM.