|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-06-2019, 05:58 PM | #1 |
Senior Member
Join Date: Aug 2018
Location: Ottawa, ON
Posts: 851
|
Factory Ford Aluminum Intake on C69?
I picked up a Ford factory aluminum intake and I'm thinking of using it on my C69 engine. I noticed a few differences:
1. Stud for generator bracket is located higher and appears a bit longer. I assume longer wide belt is available. Is this so? 2. There are two holes located in the front just below the generator stud. There is paint on the openings. Are these stock? 3. There are two vacuum? ports. I assume the one closest to the front is for the vacuum brake, the rear one is blocked, but was it used for anything? |
04-06-2019, 06:00 PM | #2 |
Senior Member
Join Date: Aug 2018
Location: Ottawa, ON
Posts: 851
|
Re: Factory Ford Aluminum Intake on C69?
Second pic.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-06-2019, 06:02 PM | #3 |
Senior Member
Join Date: Aug 2018
Location: Ottawa, ON
Posts: 851
|
Re: Factory Ford Aluminum Intake on C69?
Third pic.
|
04-06-2019, 06:19 PM | #4 |
Senior Member
Join Date: Jul 2011
Location: SF Bay Area
Posts: 6,641
|
Re: Factory Ford Aluminum Intake on C69?
It appears to be from an earlier vehicle and may not fit your application due to the height of the generator mount. Also, the runners are definitely an earlier design, but you'd be hard pressed to tell the difference in operation. You can get a better idea of the vintage from the date code cast into the underside. The rear vacuum port was intended for the windshield wipers, the front for the vacuum brake.
__________________
Alan |
04-06-2019, 06:39 PM | #5 |
Senior Member
Join Date: May 2010
Location: Lower Hutt , New Zealand
Posts: 2,126
|
Re: Factory Ford Aluminum Intake on C69?
That is not an aly intake for a c69 for engine. An aluminium one was standard on Canadian C59 and C69 engines. The intake should have a port on the passengers side at the front for an oil filler tube also there should be a stamping on top at the back starting with 11A.
GB
__________________
"you can't make honey out of dog sh*t" "You're a long time looking at the lid" |
04-06-2019, 08:51 PM | #6 | |
Senior Member
Join Date: Aug 2018
Location: Ottawa, ON
Posts: 851
|
Re: Factory Ford Aluminum Intake on C69?
Sponsored Links (Register now to hide all advertisements)
Quote:
|
|
04-06-2019, 08:54 PM | #7 | |
Senior Member
Join Date: Aug 2018
Location: Ottawa, ON
Posts: 851
|
Re: Factory Ford Aluminum Intake on C69?
Quote:
|
|
04-06-2019, 08:55 PM | #8 |
Senior Member
Join Date: Feb 2017
Location: quebec canada
Posts: 148
|
Re: Factory Ford Aluminum Intake on C69?
heres my c69 intake ,the oïl filler pipe is exactly as Graeme said. sorry for big picture !
|
04-06-2019, 09:37 PM | #9 |
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,571
|
Re: Factory Ford Aluminum Intake on C69?
it looks like a 35 manifold with the high gen mount. look on the inside, there should be a casting date
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|