Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-09-2013, 11:19 AM   #21
HCO41
Senior Member
 
Join Date: May 2013
Location: Lyndon, Vt.
Posts: 455
Default Re: Problems with new Mac's fuel pump?

As long as no one has had a failure with the intake gasket, I'll probably use it. I've had good luck, in the past, using "plug valve" grease for a good seal on gaskets like this and also works good for water pump and thermostat housing gaskets. Don't remember where I got the stuff, but its original use was a lubricant/ sealer for valves used on kerosene barrels, petcocks, etc. with tapered male and female mating parts.
HCO41 is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:11 PM.