|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-01-2013, 10:03 AM | #1 |
Senior Member
Join Date: Feb 2011
Location: Ohio
Posts: 419
|
1941 bed pieces
City:
Akron
State:
Ohio
On the bed of my wife's 41 half ton there were welding cylinder rings cut out on top of bed edge. I'm looking for a section of the top of the sides. I need top from rolled top to the bottom of 45degreee bend 2 sections 15" long. Just pieces or one entire side. Hopefully someone has a bed where the top is solid
Thanks all |
12-01-2013, 11:08 AM | #2 |
Senior Member
Join Date: Feb 2011
Location: Ohio
Posts: 419
|
Re: 1941 bed pieces
Here are the sections I need.
|
Sponsored Links (Register now to hide all advertisements) |
|
12-21-2013, 07:48 PM | #3 |
Senior Member
Join Date: Feb 2011
Location: Ohio
Posts: 419
|
Re: 1941 bed pieces
Anyone with these bed pieces? Called northern classic and no help on just pieces only whole side. Just need small sections or a whole side. Thanks again
|
12-21-2013, 08:51 PM | #4 |
Senior Member
Join Date: May 2010
Location: Manitoba Canada
Posts: 274
|
Re: 1941 bed pieces
Hi: I have a couple of box sides from 1 ton. Not sure if the top rail is same as 1/2 ton. Please give me the width of the top angled piece and size of the rolled piece on top and the height of the piece of side wall. Asking $10.00 each plus shipping.
Stewart |
12-27-2013, 06:19 PM | #5 |
Senior Member
Join Date: May 2010
Location: Manitoba Canada
Posts: 274
|
Re: 1941 bed pieces
Hi: Was out today and measured the truck box side. Top roll is 1" outside and the sloped piece is 4-1/4" If that will fit your box I can cut the pieces out for you Stewart [email protected]
|
06-29-2014, 09:33 PM | #6 |
Senior Member
Join Date: Feb 2011
Location: Ohio
Posts: 419
|
Re: 1941 bed pieces
Sponsored Links (Register now to hide all advertisements)
Thanks Mike |
|
|
Sponsored Links (Register now to hide all advertisements) |
|