Go Back   The Ford Barn > To The Editors > Questions & Suggestions

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 02-25-2014, 02:36 PM   #1
dp1743
Member
 
dp1743's Avatar
 
Join Date: Jun 2013
Location: Stoughton, MA
Posts: 39
Default Transmission cover bolts

I'm replacing the transmission cover on my 40 Ford Standard and would like to know what the correct fasteners are. I'm sure the original fasteners have been replaced. I don't think the correct setup is with the existing hexhead bolts and nuts. Does anyone know if I should be using panhead or stovehead type bolts. Also, should I use caged nut clips on the floor panel with the bolts, or, are regular nuts proper? How about any washers? Thank you all in advance for your input. Dick in MA.

Last edited by dp1743; 02-25-2014 at 05:26 PM. Reason: Spelling correction
dp1743 is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:56 PM.