Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-26-2020, 10:27 AM   #1
Bob Bidonde
Senior Member
 
Bob Bidonde's Avatar
 
Join Date: May 2010
Location: Long Island, NY
Posts: 1,959
Default Distributor Removal Tip Re Ignition Cable Clamp

Removal of the distributor also necessitates the removal of Head Nut 8 that secures the armored ignition cable clamp. A consequence of loosening / removing Nut 8 is coolant leakage into Cylinders 3 & 4. Make this simple modification to the cable clamp, and the risk of leakage goes away.
> Drain one gallon of coolant;
> Remove Head Nut 8 to release the cable clamp;
> Reinstall the head nut and torque to 55 ft-lbs for a stock head and 65 ft-lbs for a hi-compression head. The stud should protrude out of the nut enough to hold the clamp plus a jam nut;
> Replenish the coolant;

> Remove the clamp from the cable and cut the round end of the clamp as shown. Prime & paint the cut edge so it doesn't rust;
> Buy a 7/16-20 Jam Nut that is much thinner than a stock nut;
> Clamp the ignition cable using the modified clamp and the jam nut. Hence forth, only remove the jam nut to takeout the distributor.
Attached Images
File Type: jpg 190A Popout Cable Clamp Mod 331KB.jpg (58.5 KB, 93 views)
File Type: jpg 190A Popout Cable Clamp Mod 305KB.jpg (57.8 KB, 87 views)
__________________
Bob Bidonde
Bob Bidonde is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:09 PM.