|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-11-2017, 02:24 PM | #1 |
Member
Join Date: May 2010
Location: Sask. Canada
Posts: 97
|
Help with identifing Crown and pinion
The gear set on the left side is a 4.11 for a 1932-1934 diff. Can anyone help with the identity of the set on the right. It is also a 4.11. The crown gear is thicker and the pinion gear is bigger. The pinion shaft is also fatter (2") and longer (7 7/8") Both sets are Ford script
Last edited by ford33; 05-08-2021 at 02:01 PM. |
04-11-2017, 03:23 PM | #2 |
Senior Member
Join Date: May 2010
Location: Garlic Country of CA
Posts: 537
|
Re: Help with identifing Crown and pinion
'35 to '38 V8 it appears.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-11-2017, 06:07 PM | #3 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,422
|
Re: Help with identifing Crown and pinion
Yup, Those were the 10-spline years. The 6-spline took over after that. The carrier bearing size was different between the 35/36 rear axle and the 37/38 but there was no difference in the crown wheel.
|
04-12-2017, 12:19 PM | #4 |
Member
Join Date: May 2010
Location: Sask. Canada
Posts: 97
|
Re: Help with identifing Crown and pinion
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|