|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-03-2018, 10:56 AM | #1 |
Senior Member
Join Date: May 2010
Location: Eastern Iowa
Posts: 350
|
wiring stock '56 F100 wiper motor
Got a '56 Ford F100 with many uninstalled original parts in boxes and trying to wire the stock electric wiper motor I got with it.This was probably a positive ground vehicle from the factory, correct? Was it factory 1 or 2 speed? There are 3 wires coming from it. Red, Green and black...Any help in where each goes?
|
12-03-2018, 11:22 AM | #2 |
Senior Member
Join Date: May 2012
Location: Middle TN
Posts: 1,060
|
Re: wiring stock '56 F100 wiper motor
Ford went to 12v negative ground beginning with the '56 models. Check the Old Car Manual Project for a free diagram. Barring that you'll need to buy a service manual or at least a wiring diagram/schematic. https://www.google.com/search?q=tocm...active&ssui=on
__________________
Often wrong but never in doubt. |
Sponsored Links (Register now to hide all advertisements) |
|
12-03-2018, 12:15 PM | #3 |
Senior Member
Join Date: Aug 2012
Location: Abq, NM
Posts: 3,607
|
Re: wiring stock '56 F100 wiper motor
Sponsored Links (Register now to hide all advertisements)
This one is specifically '56 Ford truck... but if yours has a turn signal switch I'm noticing the diagram doesn't show it. http://diagramonwiring.blogspot.com/...al-wiring.html Here is a page with tabs to more than a few '57 to '65 wiring diagrams. Virtually all for cars but the wiring of vehicles '56 to '57 is 98% the same. (dash gauge voltage regulator was added for '57) http://www.oldcarmanualproject.com/t.../fordindex.htm . Last edited by dmsfrr; 12-03-2018 at 04:28 PM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|