|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
10-07-2014, 10:21 AM
|
#1 |
|
Member
Join Date: May 2010
Location: northport mi
Posts: 87
|
control throttle assembly
Will the a9725 used on 28-31 work on 32 model b block?
|
|
|
|
10-08-2014, 10:14 AM
|
#2 |
|
Member
Join Date: May 2010
Location: northport mi
Posts: 87
|
Re: control throttle assembly
This is a very simple question The control throttle assembly bolts on the back of the block fire wall side with 2 bolts gas petal on one side other end rod goes to carb--using a model b engine can I use same control unit???
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
10-08-2014, 10:24 AM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Fresno, Ca.
Posts: 3,636
|
Re: control throttle assembly
Yep....
|
|
|
|
|
10-08-2014, 10:25 AM
|
#4 |
|
Senior Member
Join Date: Nov 2010
Location: Fairbanks, Alaska
Posts: 767
|
Re: control throttle assembly
Glenn of northport,
The answer would be Yes, any of us that use a Model B Engine Block in a Model A chassis use the standard Throttle Assembly. Darryl in Fairbanks 20 degrees here in the Interior |
|
|
|
|
10-08-2014, 11:20 AM
|
#5 |
|
Member
Join Date: May 2010
Location: northport mi
Posts: 87
|
Re: control throttle assembly
Thank you Thank you 50 in Northport MI no snow yet
|
|
|
|
|
10-08-2014, 12:02 PM
|
#6 |
|
Senior Member
Join Date: May 2010
Location: Daytona Beach, Fl & Spencer, W. Va,
Posts: 4,442
|
Re: control throttle assembly
Sponsored Links (Register now to hide all advertisements)
MIKE  (mikeburch)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:27 AM.