|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-27-2020, 12:52 AM | #1 |
Member
Join Date: Dec 2013
Location: Victoria , Australia
Posts: 52
|
front fender aprons 47 pickup
1947 1 Ton Pickup 6 cylinder engine .Hi guys can anyone tell me if there is a bolt on each side at the lower rear of the front fender aprons that bolts to the chassis with a large rubber pad in between , I cannot get the aprons to settle toward the rear and there is a bolt hole on each side but I am not sure if it is fixed at that point , it would seem a bit agricultural to do this considering there are 2 rubber buffers toward the front on both sides along the chassis . does anyone have diagram of this at all . I am nearly finished my truck but the front clip is being a bastard to fit back on , the radiator is touching the front guard where the front panel and fender bolt up on both sides. I remember it was a pain to pull apart as well . can anyone shed some light on this please?
cheers Robin |
02-27-2020, 11:45 AM | #2 |
Member
Join Date: Aug 2017
Location: WA-OR, USA
Posts: 68
|
Re: front fender aprons 47 pickup
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|