|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-13-2017, 08:11 PM | #1 |
Senior Member
Join Date: Aug 2010
Location: Oregon
Posts: 311
|
Do I need new brake lines?
I've finished replacing wheel cylinders, shoes, etc. Upon further inspection of the old cylinders, I discovered this mess. The question I have is, should I replace the brake lines and hoses?20170413_154821.jpg
|
04-13-2017, 08:21 PM | #2 |
Senior Member
Join Date: May 2010
Location: MN
Posts: 7,053
|
Re: Do I need new brake lines?
Never is a bad thing if never replaced.
That way you'll know what condition your brake condition is in.... man |
Sponsored Links (Register now to hide all advertisements) |
|
04-13-2017, 08:24 PM | #3 |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,113
|
Re: Do I need new brake lines?
That almost looks like that cylinder was full of that yuk from the beginning. Pull that cylinder apart and post pics of what you find. That stuff would have had to go past the rubber cups and the piston to get to where we are seeing it. DD
|
04-13-2017, 08:32 PM | #4 |
Senior Member
Join Date: Jan 2015
Posts: 325
|
Re: Do I need new brake lines?
Dot 5 fluid won't do that....been using it in our 38s for years
|
04-13-2017, 08:42 PM | #5 |
Senior Member
Join Date: May 2010
Posts: 1,770
|
Re: Do I need new brake lines?
if you used dot 5 you would not have had that problem. change the rubber horses inspect the steel lines for rust & stone kinks if present replace them. rebuild master cylinder or replace. flush the lines & then use dot 5.if you use reg brake fluid & the car sits for a long time you will be doing the same thing again.reg brake fluid azorbs mosture that is why the cylinders look like that
|
04-13-2017, 08:43 PM | #6 |
Senior Member
Join Date: Jan 2014
Location: Orcas Island Washington
Posts: 4,930
|
Re: Do I need new brake lines?
Sponsored Links (Register now to hide all advertisements)
__________________
Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1947 Tonner Pickup (red) mostly stock with exception of a cummins 6at turbo diesel, 1946 Tonner Pickup (green) with 226 cu in 6 cyl flathead, 1979 Toyota landcruiser wagon, completely encased in 1947 Ford Jailbar sheet metal. Ok, cornbinder rear fenders..... 'Rusty ol' floorboards, hot on their feet' (Alan Jackson) |
04-13-2017, 09:19 PM | #7 |
Senior Member
Join Date: Aug 2010
Location: newark, delaware
Posts: 3,735
|
Re: Do I need new brake lines?
Nicopper. But buy the good stuff from Fedhill. Use the originals as patterns and its a piece of cake with the new style press type flaring tool
|
04-13-2017, 09:56 PM | #8 |
Senior Member
Join Date: May 2010
Location: near Washington, DC
Posts: 559
|
Re: Do I need new brake lines?
That crudded up wheel cylinder is not an unusual situation in cases where the system was never bled. By itself, it does not indicate that the steel lines and/or rubber hoses need to be replaced. However, replacing all the rubber lines is a good idea in any brake system overhaul, especially when the age of the existing ones is unknown.
__________________
Those who do not move do not die, but are they not already dead? |
04-13-2017, 10:50 PM | #9 |
Senior Member
Join Date: Aug 2010
Location: Oregon
Posts: 311
|
Re: Do I need new brake lines?
Looks like more work.... I've made up brake lines on two complete cars before, but body off builds. was hoping I could get a pass. I'll try to get the cylinder apart and see what's inside. thanks for the advice
|
04-14-2017, 06:44 AM | #10 |
Senior Member
Join Date: May 2010
Location: Auburn, MA
Posts: 2,106
|
Re: Do I need new brake lines?
Blow out the brake lines and see what comes out. The lines are steel and that cylinder is cast iron so that may be part of the reason for more advanced corrosion.
__________________
“The technique of infamy is to start two lies at once and get people arguing heatedly over which is true.” ~ Ezra Pound |
04-14-2017, 06:53 AM | #11 |
Senior Member
Join Date: May 2010
Location: Newington, Connecticut
Posts: 1,374
|
Re: Do I need new brake lines?
If you're starting fresh with new cyls , etc..., do the lines. Cheap insurance plus you're starting with all new components.
__________________
Barry 50 F-1 |
04-14-2017, 03:56 PM | #12 |
Senior Member
Join Date: May 2010
Location: Illinois
Posts: 2,184
|
Re: Do I need new brake lines?
+1 on Fedhill Cunifer nicop lines. Very easy to bend and work with and no rust.
http://fedhillusa.com John |
04-14-2017, 05:24 PM | #13 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,260
|
Re: Do I need new brake lines?
I always replace brake lines on these old Fords. It's a safety measure to me.
|
04-15-2017, 05:40 AM | #14 |
Senior Member
Join Date: May 2010
Location: FP, NJ
Posts: 2,770
|
Re: Do I need new brake lines?
+2 on the copper/nickel! Even with my Chinese flaring kit, I got nice flares easily and it bends so much more easily than steel. And, you can "adjust" your bend easily by hand. I just made up a 3/8" fuel line with copper nickel and I was able to bend it with a KD pliers type bender.
__________________
Don't never get rid of nuthin! |
04-15-2017, 09:31 AM | #15 |
Senior Member
Join Date: Aug 2012
Location: Perth, Western Australia
Posts: 2,687
|
Re: Do I need new brake lines?
You're just going to push the crud from the lines into your new m/cylinders
__________________
"Came too close to dying to stop living now!" |
04-15-2017, 11:16 AM | #16 |
Senior Member
Join Date: Aug 2010
Location: Oregon
Posts: 311
|
Re: Do I need new brake lines?
Thanks for the advice. I just picked up new hoses from Wagers, and ordered lines from fedhill.
|
04-15-2017, 07:40 PM | #17 |
Senior Member
Join Date: Aug 2012
Location: Perth, Western Australia
Posts: 2,687
|
Re: Do I need new brake lines?
You'll be glad you did.. Friend of mine specialises in early jeeps says he's fixed so many having to replace the ' new' wheel cylinders because clients put them on and of course don't change those old lines, costs them twice..
Your going to miss the fun of making your own lines : )
__________________
"Came too close to dying to stop living now!" |
04-15-2017, 09:11 PM | #18 |
Senior Member
Join Date: Jul 2012
Posts: 586
|
Re: Do I need new brake lines?
There are companies that will supply you with pre-bent lines for your car. Costs more but makes it easy.
|
04-16-2017, 09:41 AM | #19 |
Senior Member
Join Date: Feb 2014
Location: Harare Zimbabwe
Posts: 160
|
Re: Do I need new brake lines?
Hi All,
I recommend replacing all the metal brake pipes. Remember brake fluid is hydroscopic and absorbs moisture. The brake pipes are like a fuel tank, they rust from the inside out and although they look good from outside, the truth is they may be ready to fail on you. I had a terraplane where all the pipes looked good until an emergency stop burst a metal pipe. I now replace all pipes on cars over 25 years old as a safety concern. Viv. |
04-16-2017, 04:50 PM | #20 |
Senior Member
Join Date: Apr 2011
Location: Northern New Jersey
Posts: 370
|
Re: Do I need new brake lines?
I had a few brake lines rott out on newer vehicles thankfully in a parking lot(97 Forrd E350) and a long driveway(2000 Ford 150) NO ACCIDENTS! Makes you appreciate mechanical brakes when it happens :-)).
Better brake lines are Teflon coated but only come on more expensive cars I'm told. So now I coat all my brake lines with bees wax. In my older classic cars I put in silicon brake fluid after a complete overhaul of the brakes.i have been driving some 30 yrs. without any problems. I am amazed of the condition of the pedal and clarity of the fluid. I know silicon should not be used with road racing but as far as not absorbing moisture its my preference for longevity.
__________________
Assumption is the mother of all foul-ups. Last edited by stangblue; 04-16-2017 at 04:55 PM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|