|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-27-2018, 09:47 AM | #1 |
Senior Member
Join Date: Jul 2012
Location: Venice, FL
Posts: 648
|
Rebuilt rear end has a wine in it
Hi all,
I just built up a rear end with good castings, axles, carrier, spider etc. Also a good looking ring and pinion set. All the bearings, races and seals are new. This was done in preparation of installing a new Mitchell over drive. Problem is now that it has a wine in it. The carrier was set to 17 inch pounds preload and just a very small backlash I did not measure. After setting the preload I split the shim set left and right for the backlash. My first though is that maybe I have the pinion bearings too tight. I sure could use some advice on the problem. Thanks for your help. Al |
|
|
Sponsored Links (Register now to hide all advertisements) |
|