Crab distributor Coil and condenser

[Bubba]

I had seen that for a crab get 52-1902 coil and FA49 cond. got them a NAPA got home had the FA49 and IC7 coil coil say no External Resistor required Is that what I need to run and by pass the resistor under the dash or go back change for another one. Thanks

[BUBBAS IGNITION]

The napa #ic7 coil is a internally resisted 6 volt coil and happens to be a good one, you would not need the under dash ressitor with this coil.

The FA49 condensor is for a 37-41 helmet NOT the crab.

Crab condesnor is a FA54 and cap and rotor is cap=FA65 and FA64 rotor . Suggest buiying cap and rotor at same time then filing a bot off the rotor tip to prevent hitting....

Glad to help...

[Ken/Alabama]

Originally Posted by BUBBAS IGNITION

The napa #ic7 coil is a externally resisted 6 volt coil and happens to be a good one, you would not need the under dash ressitor with this coil.

The FA49 condensor is for a 37-41 helmet NOT the crab.

Crab condesnor is a FA54 and cap and rotor is cap=FA65 and FA64 rotor . Suggest buiying cap and rotor at same time then filing a bot off the rotor tip to prevent hitting....

Glad to help...

Did you intend to say Internal resisted not External??

[BUBBAS IGNITION]

Originally Posted by Ken/Alabama

Did you intend to say Internal resisted not External??

Yep its internally resisited and dont need the resistor....Thanks Ken

And we do know theirs NO resistor in the coil , the primary winding is would to have 1.5 ohms resistance in the winding itself.......

[Bubba]

Sponsored Links (Register now to hide all advertisements)

Will got what I could done the IC7 coil and I had an FA54 runs better than it has in a good while cap and rotor won't be in for 2 3 days.

Thanks