|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-15-2020, 10:12 PM | #1 |
Senior Member
Join Date: Jul 2016
Location: Orangeville Illinois
Posts: 461
|
U-Joint Inner Cover
I should probably know this but I don't! Which way do the two holes in the inner U-joint cover go? Up and down.... Side to side??? Don't matter..And why? Are they a means for grease? What is their purpose? I'm so confused....
|
03-16-2020, 01:14 AM | #2 |
Senior Member
Join Date: May 2010
Location: Qld, Australia
Posts: 4,212
|
Re: U-Joint Inner Cover
I think you will find it will only go one or two ways,both right.
Lawrie |
Sponsored Links (Register now to hide all advertisements) |
|
03-16-2020, 08:27 AM | #3 |
Senior Member
Join Date: Jun 2014
Location: Land of Lincoln
Posts: 3,127
|
Re: U-Joint Inner Cover
The holes are to allow grease oil to flow from the grease fitting into the inter cavity.
__________________
Don't force it with a little hammer tap, tap, tap get a bigger hammer tap done |
03-16-2020, 08:35 AM | #4 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: U-Joint Inner Cover
side to side
|
03-16-2020, 09:11 AM | #5 |
Senior Member
Join Date: Jul 2016
Location: Orangeville Illinois
Posts: 461
|
Re: U-Joint Inner Cover
Thank ya'all for the help, I knew I had two choices.....LOL
Side to side it will be... let the grease flow |
03-16-2020, 12:35 PM | #6 |
Senior Member
Join Date: May 2016
Location: Glide, Oregon
Posts: 1,336
|
Re: U-Joint Inner Cover
Sponsored Links (Register now to hide all advertisements)
Last edited by Ruth; 03-16-2020 at 12:42 PM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|