|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-25-2018, 09:03 AM | #1 |
Senior Member
Join Date: Oct 2016
Location: harpursville ny
Posts: 1,040
|
38 221 engine questions
i opened up a 38 engine i have had for 40 yrs. to check its condition. pistons are steel and measure about 3.036. is that a stock piston for a 3.062 bore? cyl. bore measures about 3.077. what is the wear limit before boring is needed? last, i measured valve clearances and all are .004-.005 over spec. is this normal and what would be the probable cause? all other engines i had had tight clearances and valve stems had to be ground. thanks, Mark
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|