Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-15-2020, 09:50 PM   #1
my4dv8
Senior Member
 
Join Date: Aug 2010
Location: New Zealand
Posts: 841
Default 32 pickup speedo cable

Where is the correct routing for a 32 pick up speedo cable , as in where does it enter the cabin. Some long forgotten person has put new floors in ours.
Also what length is the cable supposed to be? When I know I will search for a new inner and outer. The turtle faces the left ,is that correct?
my4dv8 is offline   Reply With Quote
Old 01-15-2020, 11:37 PM   #2
DavidG
Senior Member
 
DavidG's Avatar
 
Join Date: May 2010
Posts: 6,373
Default Re: 32 pickup speedo cable

The gear housing faces to the right and the cable passes through a dedicated hole in the center cross member and then is routed upward along the right side of the outside of the firewall where it is retained with a clip that is attached to a clinch nut on the firewall. It then passes through the firewall into the interior and up to the speedometer. The attached photo shows the routing on the firewall (dash). The routing is the same for both LHD and RHD '32s, fours and V8s.

The cable housing (B-17261) was 60.82" long and the inner cable (B-17262) was 61.81" in length.
Attached Images
File Type: jpg Book photos 025.jpg (67.2 KB, 25 views)
DavidG is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:50 PM.