Go Back   The Ford Barn > General Discussion > Model T (1909-1927)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-06-2020, 08:40 PM   #1
dmdeaton
Member
 
Join Date: Aug 2017
Location: Southern Ohio
Posts: 41
Default Rear Axle Question

I am installing safety hubs on my large drum rear axle. Hyatt bearing on left side was pretty tight to get out. Right side was fine.
Timken bearings inside the new hubs are tight going on left side.
Left measures about 1.063.
Right side is fine and slides right on.
Both axles are original Ford
Axle diameter is supposed to be 1.062
Timken bearings spec out at 1.0625

I think I am kinda screwed on this one and maybe need to change the axle?

any thoughts?
dmdeaton is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:46 PM.