|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-07-2015, 08:46 AM | #1 |
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,573
|
34 v8 torque tube length please
can anyone give me the measurement of a correct tube and drive shaft so i could identify one in a pile. v8 and B's were different? thanks, skip
|
08-07-2015, 10:30 AM | #2 |
Senior Member
Join Date: May 2010
Location: so cal, placerville, vegas
Posts: 1,394
|
Re: 34 v8 torque tube length please
A measurement that I wrote down for TT length, 34 V8, is 61-7/8-in.
The number I recorded for D/S length is 60-3/16. I also wrote down some measurements of weld-to-weld, pin hole to weld, front end (snoot) length - for in case you find cut-up parts. Again, all for 34 V8 |
Sponsored Links (Register now to hide all advertisements) |
|
08-07-2015, 10:36 AM | #3 |
Senior Member
Join Date: May 2010
Location: westport ct.
Posts: 166
|
Re: 34 v8 torque tube length please
Drive shaft is 60 5/32 Torque tube is 61 13/16 .
|
08-07-2015, 03:27 PM | #4 |
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,573
|
Re: 34 v8 torque tube length please
thanks very much!
|
08-07-2015, 05:23 PM | #5 |
Senior Member
Join Date: May 2012
Location: Queensland, Australia
Posts: 10,366
|
Re: 34 v8 torque tube length please
Sponsored Links (Register now to hide all advertisements)
The length of the Drive shaft in the V-8 = 60 5/32” while the Drive shaft in the 4 cylinder = 58 7/16” It follows that the Tube on the 4 cylinder was shorter by same amount. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|