|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
01-21-2011, 08:14 PM
|
#1 |
|
Senior Member
Join Date: Oct 2010
Location: Peabody, MA
Posts: 471
|
1935 Rear Axle/drive shaft assembly
I need a 1935 rear axle and drive shaft assembly with radius rods. I don't need the spring or backing plates. 3.54 gear ratio would be preferrable.
|
|
|
|
01-21-2011, 10:01 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
|
Re: 1935 Rear Axle/drive shaft assembly
Good luck on the 3.54.
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
01-21-2011, 10:48 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Brisbane, Australia
Posts: 166
|
Re: 1935 Rear Axle/drive shaft assembly
|
|
|
|
|
01-22-2011, 08:34 AM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Near Rising Sun, Maryland
Posts: 10,858
|
Re: 1935 Rear Axle/drive shaft assembly
It took me almost two years to find a set of 3.54's with a ten spline pinion....that I could actually afford. You can buy new reproduction sets with six spline pinions for $350 and convert your driveshaft to six spline. Best bet is to put an ad in the wanted sections on this and other old Ford websites.
__________________
John "Never give up on what you really want to do. The person with big dreams is more powerful than one with all the facts". Albert Einstein |
|
|
|
|
01-22-2011, 10:37 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,768
|
Re: 1935 Rear Axle/drive shaft assembly
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:53 PM.