|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-29-2019, 10:14 AM | #1 |
Senior Member
Join Date: Jul 2016
Location: Missouri
Posts: 424
|
53 Ranchwagon Throwout Bearing
Ordered a clutch kit for my Ranchwagon, 3 speed, flathead, stock..Went to install the throwout bearing, and the clips for the shift fork are too close together. About 2 inches from center to center on the clips, and I need about 2 1/4. Are there various options for my application, or is this a bad manufacture? Everything else seems fine. 9.5 inch clutch, and the hub was part of the bearing. I haven't really seen any options for different throwout bearings. Any ideas? Thanks
|
08-30-2019, 11:46 AM | #2 |
Senior Member
Join Date: Jul 2016
Location: Missouri
Posts: 424
|
Re: 53 Ranchwagon Throwout Bearing
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|