Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 07-31-2016, 12:00 PM   #1
1956 F100
Junior Member
 
1956 F100's Avatar
 
Join Date: Jan 2012
Location: Louisiana
Posts: 15
Default !934 Window Channels

I have a window kit from Vintique for my 34 sedan. I need to cut the channel to work on my car. Would anyone have a set of original that they could take dimensions off of? It looks like they need to be cut on both ends. I am currently working on installing the rear windows. Any help is greatly appreciated. Gary
1956 F100 is offline   Reply With Quote
Old 07-31-2016, 01:42 PM   #2
johnboy34
Senior Member
 
Join Date: Jan 2013
Location: Seattle
Posts: 146
Default Re: !934 Window Channels

I put some links on your other thread. I can offer that if you have glass, have someone hold it in place then hold up the channel for measurement. Shorten it just enough to not hit the end channels ( after sliding back also ). Then put it on the glass ( mocked up in the car, with the regulator installed also ) Mark where it will need to be on the glass, remove and install channel to glass. I know, not much room, and the slide back lower post and stop screw hole of Vintique channels are off too. Makes it a bitch, That's where the other links come in handy. Make sure that part ( regulator and channel ) work together on the bench first. Hope some of this helps, good luck, you will get it.
johnboy34 is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:03 AM.