The Ford Barn

Joop · 11-17-2018, 08:51 AM

.
Looking to find 2 Deck Drain Plug Rubbers
Located toward the bottom corners on the Deck Drain Trough (deck drain)
assembly, are two holes, left and right, for which the arm (deck door hinge) and base assembly, left and right, were attached for the attachment of the hinges for the Deck Door Rumble Seat assembly.
See pictures (provided by Marco Tahtaras and Steve Plucker)

..

1931 flamingo · 11-17-2018, 12:19 PM

Have you ck'd with Restoration Supplies in Escondido, CA?? They have a web site.
Paul

Joop · 11-18-2018, 02:02 PM

Thanks Paul

Checked there website but non available :-((

Tom Wesenberg · 11-18-2018, 02:36 PM

Metro Rubber in the Twin Cities makes lots of rubber parts for older cars and trucks.

Dale G. · 11-18-2018, 05:30 PM

Sponsored Links (Register now to hide all advertisements)

Joop,

The large ones, you can get from the vendors. You will probably have to grind the tops of them down a little to make the lid fit closed. The small ones I made for myself. If you cannot find any that are close to the spec I will make you some. Dale.

11-17-2018, 12:19 PM	#2
1931 flamingo Senior Member Join Date: May 2010 Location: new britain,ct 06052 Posts: 9,390	Re: Trunk Lid rubber parts Have you ck'd with Restoration Supplies in Escondido, CA?? They have a web site. Paul

11-18-2018, 02:02 PM	#3
Joop Senior Member Join Date: May 2010 Location: Glendale, AZ Posts: 2,950	Re: Trunk Lid rubber parts Thanks Paul Checked there website but non available :-((

11-18-2018, 02:36 PM	#4
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: Trunk Lid rubber parts Metro Rubber in the Twin Cities makes lots of rubber parts for older cars and trucks.

11-18-2018, 05:30 PM	#5
Dale G. Senior Member Join Date: May 2010 Location: Jacksonville, FL Posts: 292	Re: Trunk Lid rubber parts Sponsored Links (Register now to hide all advertisements) Joop, The large ones, you can get from the vendors. You will probably have to grind the tops of them down a little to make the lid fit closed. The small ones I made for myself. If you cannot find any that are close to the spec I will make you some. Dale.