|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-08-2020, 03:17 PM | #1 |
Senior Member
Join Date: May 2010
Location: Ashland KY
Posts: 1,159
|
Pressure plate finger adj
Have done a lot of searches for this info,lot of model A infobut cant find the measurements for a V8,,Haveread a lot about don’t mess with the adj,but if there are not equal,they need adj!!!I believe it’s 11/16 from top of pp frame to fingers with the pp bolted to a FW with disc in place,,,read another place that said 1 1/4 for a 9 inch ,1 3/16 for a 10 inch pp,,mm says look at chart but where’s the chart??
__________________
DON P |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|