Go Back   The Ford Barn > General Discussion > Model A (1928-31)
Reload this Page Valve Tool

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-23-2020, 10:40 AM   #1
HCO41
Senior Member
 
Join Date: May 2013
Location: Lyndon, Vt.
Posts: 456
Default Valve Tool
Some descriptions describe this tool for Ford Model A and T vehicles. Is it specific or a generic valve spring tool. Does it do the job?
Apparently it is an early version of a DZ tool because DEE-ZEE is spelled out on the orange release lever. I don't do pictures but, here is an Ebay ad for it:


http://www.ebay.com/itm/Vintage-Kay-...cAAOSwEphb~Grj


Howard
HCO41 is offline   Reply With Quote
Old 01-23-2020, 12:20 PM   #2
Jacksonlll
Senior Member
 
Jacksonlll's Avatar
 
Join Date: Jul 2012
Location: Michigan-- Member of Oakleaf of MARC
Posts: 1,686
Send a message via ICQ to Jacksonlll
Default Re: Valve Tool
Their are a lot of valve spring tools. Some work and some don’t. This one should work just fine. I usually borrow several and pick the one that works best.
Jacksonlll is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 01-23-2020, 01:46 PM   #3
Jim Brierley
Senior Member
 
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,084
Default Re: Valve Tool
Sponsored Links (Register now to hide all advertisements)
It should work, however I prefer modern 'C' clamp design, they are easier to use and leave more room for your fingers to get in there and work.
Jim Brierley is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:41 AM.