|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-13-2020, 12:25 PM | #1 |
Junior Member
Join Date: Mar 2020
Location: Ontario
Posts: 2
|
Windshield corner brackets
I am changing the windshield frame corner brackets and find they are staked in place. Any advice on getting the brackets out would be appreciated. I’m thinking of drilling a small hole in the stakes and pulling with a screw but am open to suggestions.
|
04-13-2020, 01:46 PM | #2 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: Windshield corner brackets
if you are not concerned about the paint, take a pair of vise grips and grab a hold of the bracket. now with a torch heat up the dimple red hot and tap the vise grips with a hammer, when you put the new bracket in just reset the dimple with a punch.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-13-2020, 03:21 PM | #3 |
Junior Member
Join Date: Mar 2020
Location: Ontario
Posts: 2
|
Re: Windshield corner brackets
Sponsored Links (Register now to hide all advertisements)
I did just paint the frame but not a big deal to do it again, I will try a pencil point tip to minimize paint damage. Thanks again. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|