|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-21-2015, 05:03 PM | #21 | |
Senior Member
Join Date: Jan 2014
Location: N Illinois
Posts: 447
|
Re: I can see clearly now
Quote:
No gaskets, tolerance is tight on gears and cover. Good spring. I do not suspect the pump since 3 different pumps did the same. When I run the pumps with a drill it sends oil out 6-8 inches on each side. I suspected a blockage in the block...none found. The only thing that makes any sense is the oil is going somewhere other than the outlet pipe and I think the only place it can go before the outlet is the center bearing of the cam. It's disappointing as I wanted to get a good video of the oil flow... may have to use a different engine. |
|
03-21-2015, 05:04 PM | #22 |
Senior Member
Join Date: Jan 2014
Location: N Illinois
Posts: 447
|
Re: I can see clearly now
|
Sponsored Links (Register now to hide all advertisements) |
|
03-21-2015, 05:05 PM | #23 |
Senior Member
Join Date: Jan 2014
Location: N Illinois
Posts: 447
|
Re: I can see clearly now
|
03-21-2015, 05:10 PM | #24 | |
Senior Member
Join Date: Jan 2014
Location: N Illinois
Posts: 447
|
Re: I can see clearly now
Quote:
Remember...."The amount of knowledge gained is directly proportional to the amount of equipment ruined." |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|