View Single Post
Old 11-24-2014, 01:21 PM   #15
Joe K
Senior Member
 
Joe K's Avatar
 
Join Date: Jul 2010
Location: Cow Hampshire
Posts: 4,175
Default Re: Cracked block repair

Quote:
Originally Posted by Tom Wesenberg View Post
J and M sure does nice work.

Here are two pictures of a junk block I cut up to use as a jig when I make engine holders for the engine stand. This is cut through the right side of number one cylinder, and is 1/8" or a hair over.
1/8" and 32tpi would give you the four threads. Or go with 8-40 screws?

Joe K
__________________
Shudda kept the horse.
Joe K is offline   Reply With Quote