View Single Post
Old 05-20-2019, 10:33 AM   #11
34billct
Senior Member
 
34billct's Avatar
 
Join Date: May 2010
Location: westport ct.
Posts: 166
Default Re: why did my helmet distributor housing just crack? new rotor .

I have found that nothing makes the job of installing the distributor as easy as using two studs to align the gasket and distributor. Turn the rotor and and when the tang aligns the distributor will slid back tight to the block, put in the third bolt to hold it in place remove the studs install the other two bolts and you are finished.
34billct is offline   Reply With Quote