View Single Post
Old 08-18-2019, 03:01 PM   #10
mike657894
Senior Member
 
mike657894's Avatar
 
Join Date: Oct 2015
Location: Bay City Michigan
Posts: 936
Default Re: New clutch - should the throw out bearing disengage?

I have seen 3/4in and 7/8in as recommended measurements. not every clutch disc,pressure plate, fly wheel, throw out bearing is going to be the same thickness. And I think the gap shrinks with clutch wear. you could attempt to tighten the nuts and keep turns consistent around the circle by counting flats/turns on the nuts. go one turn at a time until the bearing stops spinning.
mike657894 is offline   Reply With Quote