Thread: cowl lacing
View Single Post
Old 05-10-2013, 10:52 PM   #3
Tom Wesenberg
Senior Member
 
Tom Wesenberg's Avatar
 
Join Date: May 2010
Location: Mpls, MN
Posts: 27,209
Default Re: cowl lacing

You must be talking about the 1930-1 kit with a J hook attached to each end of the lacing. I use an awl to poke holes in one end of the lacing, then rivet the J hook and stick it into the middle slot. Then place the welt in position and measure where it needs to be cut at the other end. Cut it so the J hook can be rivetted just like the first one and stuck into the middle slot. Now you can use the awl to poke holes where the screw goes on each side to tighten it up.

The 1928-9 had a small J hook in the center on top, which is used to tighten and hold the lacing.
Tom Wesenberg is offline   Reply With Quote