Quote:
Originally Posted by Special Coupe Frank
I just received from Snyders my new head gasket, moly-studs & nuts, and tapped water outlet for my '28.
I've read commentary about Fel-Pro and their "R-3" copper gasket which was designed to work on engines with large re-bores (0.100"), which leaves less gasket between the cylinder bores between 1 & 2 and 3 & 4.
Does anyone have a width on the stock gasket at this spot ?
( I have a blown R-3 I can measure...)
Thanks !
SC Frank
|
I have an UNUSED Fel Pro 7013 R-1 here. It measures .030.