Re: carburetor 13/32 deep well socket
Obviously time for an update.
This project has proven to be a bit more time and tooling consuming than originally thought.
We decided to run 150 pieces minimum for the first run. I have all but the last 20 or so broached. Due to work, racing season, family and other reasons, I have not made the progress I thought I would make.
At this point I am considering finishing the broaching, then hardening, quench and temper, and not doing the stamping which will no doubt take considerable time.
If I skip the stamping I should be able to have the sockets done in the next few weeks.
Hopefully everyone is ok with this, and I assure you the functionality of the finished product will be above expectations.
Should you have any questions please post to this thread, or pm/email me directly.
Hope all is well.
Bill
|