The Ford Barn - View Single Post

PeteVS · 01-15-2014, 08:33 PM

Interesting. Most of the pictures show the "top" side of the rotor, the one with the ejector pins. The fins on that side look to have very little draft. Is that the feature that's hanging up in the mold? There was one picture back at the beginning of the thread showing the "bottom" and the bosses there appear to have a heavy draft angles on the outside. They shouldn't be causing problems. Are there problems with the ID's in those bosses?

01-15-2014, 08:33 PM	#94
PeteVS Senior Member Join Date: May 2010 Location: FP, NJ Posts: 2,770	Re: Harmon Collins Rotors ????? Interesting. Most of the pictures show the "top" side of the rotor, the one with the ejector pins. The fins on that side look to have very little draft. Is that the feature that's hanging up in the mold? There was one picture back at the beginning of the thread showing the "bottom" and the bosses there appear to have a heavy draft angles on the outside. They shouldn't be causing problems. Are there problems with the ID's in those bosses? __________________ Don't never get rid of nuthin!