Thread: Door sag
View Single Post
Old 12-07-2017, 10:20 AM   #2
john charlton
Senior Member
 
john charlton's Avatar
 
Join Date: May 2010
Posts: 1,304
Default Re: Door sag

Check that the cab is square . Get a tape measure and diagonally measure the cab door gap . It should be the same as the good fitting door . If it is out of true it is easy with a suitably cushioned porta power to push it square ,do this with great caution . If the cab is square then it is the hinges . They are easy to bend with a large crescent wrench adjusted to slip on the hinge horizontally . Use a long thin rod to ensure that the three hinges remain in line on both the door and cab . I am now building P/U cab no.4 and this is a very common problem but an easy fix .

John in very windy storm"Caroline" Suffolk County England.
john charlton is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)