Quote:
Originally Posted by Sparky
I have a little homemade bell crank linkage that is attached to the top of the engine.d
|
That is what I did to, I turned a ring that fit over a head nut, made a small divot in the nut for the head of a screw to fit into, and made a Bell-crank that attached to the ring to transfer the linkage over the head. Locknuts and loctite seem as though it will keep in place.
I guess you can simply bend the Spark Advance rod. Most sane folks do,
but I really do not like the looks of the bent rod. I used a throttle rod set to each side of the Bell-crank.