The Ford Barn - View Single Post - bell housing for flathead to T-5 transmission

tiquer · 12-14-2012, 03:31 PM

The input shafts are different lengths . I believe the truck one being the longer of the two.The input shaft in the mustang T-5 is the right length but needs the s10 tail shaft housing swap done. the bottom two bolt holes line up also. The top two require some modes done to the truck bell.

12-14-2012, 03:31 PM	#7
tiquer Senior Member Join Date: Jun 2010 Location: Kamloops B.C. Posts: 392	Re: bell housing for flathead to T-5 transmission The input shafts are different lengths . I believe the truck one being the longer of the two.The input shaft in the mustang T-5 is the right length but needs the s10 tail shaft housing swap done. the bottom two bolt holes line up also. The top two require some modes done to the truck bell.