12-14-2012, 02:57 PM
|
#6
|
Senior Member
Join Date: May 2010
Location: Granger (Northern) Indiana
Posts: 1,520
|
Re: bell housing for flathead to T-5 transmission
Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by George/Maine
I have a 53 f100 3 speed flathead has like say 55 trans.
Can this bellhousing be used to go with t5 trans,and what may have to be done to use it.
|
The F-100 Lt. duty 3-speeds (not sure about the HD 3 speed) used the same B/W T-10 4-bolt pattern as the '49-'53 Ford cars, so any adaptor that fits them should work on your truck, as long as the inputs are the same length.
Quote:
Originally Posted by rotorwrench
I'm sure the Ford Car type bellhousings from 49 to 53 can be used with a different adapter but most folks use the Hogs Head unit so they can still use the rotating equalizer type clutch release shaft with the old style fork. With this in mind, it just depends on what type of clutch actuation system works for your application.
|
The one exception is the '51 Mercury full cast bell with the '40-'48 clutch cross shaft.
|
|
|