The Ford Barn - View Single Post

62pan · 05-04-2016, 08:17 PM

The K member I used is cut down to fit the A frame and so are the K member legs. I used a 32 brake mount and 34 pedals. Using the 34 pedals put them in the same location as the A pedals. There are other options. You could use a pickup F1 trans mount. They are alot cheaper than a 32 K member. Still in your time period. If you do a search on the Hamb I'm sure you will see what I am talking about. You can then make a wishbone and brake mounts designed for that.

What Charlie said about the gears is correct. The only issue is the order in which they are assembled. I would have to check Van Pelts book to see what I did.

05-04-2016, 08:17 PM	#14
62pan Senior Member Join Date: May 2010 Location: Middletown Pa Posts: 391	Re: A & B Running Gear For "TROG" The K member I used is cut down to fit the A frame and so are the K member legs. I used a 32 brake mount and 34 pedals. Using the 34 pedals put them in the same location as the A pedals. There are other options. You could use a pickup F1 trans mount. They are alot cheaper than a 32 K member. Still in your time period. If you do a search on the Hamb I'm sure you will see what I am talking about. You can then make a wishbone and brake mounts designed for that. What Charlie said about the gears is correct. The only issue is the order in which they are assembled. I would have to check Van Pelts book to see what I did.