The Ford Barn - View Single Post

Ruth · 06-10-2019, 08:42 AM

I recently bought a harmonic balancer from Engine Restorations in New Zealand that is machined steel. I have not had a chance to install yet. Nice looking unit.

I doubt you will ever have to replace it on the side of the road. Good thing too, it is quite a bit thicker (and heavier) than a Model A pulley.

06-10-2019, 08:42 AM	#16
Ruth Senior Member Join Date: May 2016 Location: Glide, Oregon Posts: 1,339	Re: Two piece crank shaft pulley I recently bought a harmonic balancer from Engine Restorations in New Zealand that is machined steel. I have not had a chance to install yet. Nice looking unit. I doubt you will ever have to replace it on the side of the road. Good thing too, it is quite a bit thicker (and heavier) than a Model A pulley.